[Network Control]; [Pjlink] - Panasonic PT-TMZ400 Operating Instructions Manual

3) Press qw to switch the [COMMAND PROTECT] setting.
[ENABLE]
[DISABLE]
f The confirmation screen is displayed once the setting is switched.
4) Press qw to select [OK], and press the <ENTER> button.
f The [COMMAND PROTECT] screen is displayed.
5) Press as to select [PASSWORD], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
6) Press asqw to select a character, and press the <ENTER> button.
f Enter the password of the administrator account.
7) After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [COMMAND PROTECT] screen is displayed.
8) Press asqw to select [OK], and press the <ENTER> button.
Note
f When [COMMAND PROTECT] is set to [DISABLE], connection authentication is not performed, making it vulnerable to threats on the
network. Be aware of the risks before making settings.
f For details on how to use the command control function, refer to "Control commands via LAN". (x page 146)

[NETWORK CONTROL]

Set the network control of this projector.
Setting the password of the administrator account (x page 98) is required for using the network function of the
projector.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item and press qw to change the setting.
[WEB CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D. D.]
4) Press as to select [OK] and press the <ENTER> button.
Note
f If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.

[PJLink]

Set the PJLink function to control and monitor the projector using the PJLink protocol.
Setting the password of the administrator account (x page 98) is required for using the PJLink function of the
projector.
Note
f If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
Chapter 4 Settings - [NETWORK] menu
Connect to the projector in protected mode.
The user name and password of the administrator account are required for the connection
authentication.
Connect to the projector in non-protected mode.
Connection authentication is not performed.
Set to [ON] to control with the web browser.
Set to [ON] to control with the <SERIAL IN> terminal control command format (x page 149). Refer
to "Control commands via LAN" (x page 146).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
ENGLISH - 101