Panasonic PT-TMZ400 Operating Instructions Manual page 44

2) Press the <ENTER> button to proceed to the following initial setting.
Initial setting (projector setup)
If necessary, change the setting of each item.
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
SCREEN POSITION
STANDBY MODE
ENTER
SELECT
1) Press as to select an item.
Item
[PROJECTION METHOD]
[SCREEN FORMAT]
[SCREEN POSITION]
[STANDBY MODE]
2) Press qw to switch the setting.
f When all settings are completed, proceed to Step 3).
3) Press the <ENTER> button.
f Confirm the setting value and complete the initial setting.
Setting [PROJECTION METHOD]
If the screen display is upside down or is reversed, please change the settings, refer to "Installation mode"
(x page 32). After initialization, you can change the settings from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press as to select the [PROJECTION METHOD].
2) Press qw to switch the settings.
f When set to [AUTO], the built-in angle sensor detects the orientation of the projector and automatically
switches to [FRONT/DESK] or [FRONT/CEILING]. Normally, set to [AUTO].
f To project from the rear of the screen, select [REAR/DESK] or [REAR/CEILING] (using a translucent
screen).
Setting [SCREEN FORMAT] and [SCREEN POSITION]
Set the screen aspect ratio and display position according to the screen being used. When the initial setting is
complete, you can change the setting from the [DISPLAY OPTION] menu → [SCREEN SETTING] → [SCREEN
FORMAT]/[SCREEN POSITION].
44 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector
INITIAL SETTING
中文 ( 简体 )
ENTER
SELECT
PT-TMZ400, PT-TMW380
AUTO
16:10
NORMAL
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
protocol commands.
RETURN
Set [PROJECTION METHOD] depending on the installation mode.
Set the aspect ratio of the screen.
Set the display position of the screen.
Set the operation mode during standby.
PLEASE SELECT LANGUAGE.
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
SCREEN POSITION
STANDBY MODE
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
ENTER
SELECT
RETURN
Description
PT-TMX380
AUTO
4:3
NORMAL
protocol commands.