Genie GS-69 Series Instructions Manual page 9

Inspection and Repair Instructions
PROCEDURE
Oscillate Hose Routing
1 Turn the key switch to platform controls and
pull out the red Emergency stop buttons to the
on position at both the ground and platform
controls. Start the engine.
2 Raise the platform to approximately 10 ft / 3 m.
3 Lift the safety arm and move it to the center of
the linkage and rotate to a vertical position.
4 Lower the platform onto the safety arm.
5 Turn the machine off.
6 Locate and remove the chassis hose cover and
set aside. Refer to illustration 5, item A.
A
illustration 5
6
7 Open the ground controls compartment and
locate the function manifold. Refer to
illustration 6, item A.
8 At the steer end of the machine locate the 2
oscillate cylinders. Refer to illustration 7,
item A.
RIGHT
A
GS-69 RT Models
A
illustration 6
LEFT
illustration 7
Part No. 237339
REV A
B