Genie GS-69 Series Instructions Manual page 8

REV A
Axle Limit Switches
1 At the non-steer end of the machine, locate and
remove both axle covers. Set the covers and
retaining fasteners aside. Refer to illustration 3
item A.
illustration 3
2 At the ground controls side of the machine
locate the 2 oscillate limit switch harnesses
located in the non-steer axle. Refer to
illustration 4, item A.
A
illustration 4
Part No. 237339
3 Locate the 3 pin connector harness. Using a
volt meter, check continuity from the black wire
in pin C to J5 pin 12 at the ground control box.
Refer to illustration 2 for the J5 location.
There is good continuity. Continue to step 5.
There is no continuity. Continue with step 4.
4 Swap the 3 pin harness with the one on the
A engine side of the machine in the non-steer
axle and repeat step 3.
Note: If there is still no continuity after repeating
step 3 check the meter lead connections and
meter setting.
5 Locate the 4 pin connector harness. Using a
volt meter, check continuity from the white wire
in pin 4 to J12 pin 6 at the ground control box.
Refer to illustration 2 for the J12 location.
There is good continuity. Continue to step 7.
There is no continuity. Continue with step 6.
6 Swap the 4 pin harness with the one on the
engine side of the machine in the non-steer
axle and repeat step 5.
Note: If there is still no continuity after repeating
step 5 check the meter lead connections and
meter setting.
7 Install the axle covers and securely tighten the
retaining fasteners. Do not over tighten.
8 Close the ground control box. Continue to
Oscillate Hose Routing.
GS-69 RT Models
Inspection and Repair Instructions
PROCEDURE
5