Genie GS-69 Series Instructions Manual page 10

REV A
9 Using illustration 8 as a guide, verify that the
oscillate hoses are routed correctly from the
function manifold to the oscillate cylinders.
The hoses are routed correctly. Continue to
Axle Pins.
The hoses are not routed correctly. Continue
with step 10.
FUNCTION
MANIFOLD
E
R
illustration 8
10 Remove the cylinder cover from the oscillate
cylinder and correct the hose routing. Refer to
illustration 7, item B.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
11 Install the cylinder cover. Continue to Axle
Pins.
Note: Do not install the chassis hose cover or
lower the platform at this time.
Part No. 237339
Axle Pins
Non-steer end:
1 At the non-steer end of the machine locate the
2 axle pivot pins. Refer to illustration 9,
item A.
A
E
R
2 Measure the distance from the chassis
bulkhead to the tapered end of the pivot pin
towards the center of the machine. Refer to
illustration 10.
It measures 0.250 inches / 6.35 mm or greater.
Continue with step 3.
The pivot pin is less than specified. Tag and
remove the machine from service. Contact the
Genie parts department for a replacement pin
kit. You must reference Safety Notice 110008
when ordering. Continue to the Steer end pin
inspection.
Note: If the pivot pins need to be replaced do not
continue to section Test the Oscillate Axle until
the pins have been replaced.
GS-69 RT Models
Inspection and Repair Instructions
PROCEDURE
illustration 9
7