Genie GR-15 Installation Instructions Manual
Smartlink software
Hide thumbs
Also See for GR-15:
- Service manual (204 pages) ,
- Operator's manual (60 pages) ,
- Operators manual with maintenance information (42 pages)
Related Manuals for Genie GR-15
Summary of Contents for Genie GR-15
- Page 1 Installation Instructions SmartLink Software GR-12/15/20 GRC-12 QS-12/15/20 GS-30/32/46 GS-46AV GS-47 GS-69 DC GS-69 Bi-Energy X-12 X-14 Part No. 216767 Rev C January 2016...
-
Page 2: Observe And Obey
Other locations 0031 653 221 908 Note: These installation instructions only apply Middle East: 0097 143 391 800 or to the Genie models listed on the front cover. 0097 150 459 7937 Australia: 61 7 3456 4444 All other locations... -
Page 3: Software Version
Rev C Instructions Procedure Procedure Software Version SOFTWARE REV Note: Before proceeding verify the version of software installed on your machine. The 00000.0 Hours software revision is displayed at the GCON LCD. Turn the key switch to the ground controls or platform controls position. -
Page 4: Loading Or Updating Machine Software
Note: Some models will require opening the ground a web browser and navigate to the following control box to access the GCON. location for the Genie Machine Software Download Turn the key switch to the ground controls portal, http://firmware.genielift.com. Perform a... - Page 5 Result: The following screen will be displayed. 1 diagnostic port Select the Choose File button and navigate to the downloaded Genie Flash file (.gff). Connect one end of a CAT5 Ethernet cable into the diagnostic port. Connect the other end into Note: Verify it is the correct flash file.
- Page 6 Instructions Rev C Procedure Machine Application Mode 11 Select the Reprogram Device(s) button to start the ECM software update. Open the GCON compartment. Result: The following screen will be displayed Note: Some models will require opening the ground after the software update is complete. control box to access the GCON.
- Page 7 Note: The username and password are case sensitive. Result: The following screen will be displayed. 10 Select the Choose File button and navigate to the downloaded Genie Flash file (.gff). Note: Verify it is the correct flash file. Part No. 216767 SmartLink Software...
- Page 8 Instructions Rev C Procedure 11 Select the Load Flash File button to verify the 14 Push in the red Emergency Stop button and file is a .gff file. disconnect the CAT5 cable from the GCON. Result: The following screen will be displayed. 15 Secure the diagnostic port cover using the retaining fasteners removed in step 5.