Adjustment - Ricoh IM CW2200 User Manual

Adjustment

Auto Adjust Head Position
If printing produces misaligned verticals or blurred colors, printing the test pattern will re-calibrate the
machine. The test pattern differs depending on the print quality.
• Printing the test pattern consumes ink. Perform this function only when necessary.
• Perform no other operations while the test pattern is printing.
• An error will occur and test patterns will not print if:
• There is a misfeed.
• One of the machine's covers is open.
• The machine is performing maintenance operations.
• The machine has run out of ink.
• The machine has run out of paper.
• The ink collector unit is full.
• An adjustment sensor failure occurred while performing an adjustment.
1. Press [Settings] on the Home screen.
2. Press [Maintenance]
3. Select the paper input location for the head position you want to adjust.
4. Check the settings for preventing paper abrasion, paper type, and paper thickness.
• Adjustment results vary depending on the Prevent Paper Abrasion mode's status. If you
perform an adjustment while Prevent Paper Abrasion mode is enabled and do not want to
print using this mode, cancel Prevent Paper Abrasion mode, and then perform the adjustment
again.
• Check the settings of paper type and paper thickness in [Paper Type/Thickness] under
[Settings] [Paper Input Location/Paper Settings]
5. Press [Print Quality] to select the write mode.
6. Press [OK].
7. Press [Adjustment]
[Auto Adjust Head Position].
[OK].
Adjusting the Print Quality
[Paper Size/Paper Type].
253