Ricoh IM CW2200 User Manual page 228

9. Troubleshooting
Message
"Not all of the image will
be scanned. Check the
ratio and then press
[Start] again."
"Programmed. Cannot
program the
destination(s) that is not
programmed in the
address book."
"Programmed. Cannot
program the folder
destination(s) with
protection code(s)."
"SMTP authentication
email address and
administrator email
address mismatch."
"Some invalid
destination(s) contained.
Do you want to select
only valid
destination(s)?"
226
Cause
The scaling factor
specified in [Scan Ratio]
is too large.
The paper size specified
in [Scan Ratio]
[Specify Size] requires a
reduction value smaller
than 25%.
A folder specified by
Manual Entry is
included among the
programmed
destinations.
A destination specified
with a protection code is
included among the
programmed
destinations.
The SMTP
authentication e-mail
address is not registered
in the administrator e-
mail address.
The group contains an
e-mail address.
Solution and reference
Specify a smaller value in [Send Settings]
[Scan Ratio].
Specify a paper size for which a reduction
ratio greater than 25% is specified in [Send
Settings] [Scan Ratio]
Register the destination in the address book of
the machine, and then register it to a program.
• You cannot program a destination
specified with a protection code. Specify
this destination individually.
• To program this destination, cancel the
protection code and then register the
destination to a program.
See "Using the Protection Function to
Prevent the Misuse of Addresses", User
Guide (Full Version).
Register the SMTP authentication e-mail
address in [Settings] [System Settings]
[Send (Email/Folder)]
[Administrator's Email Address].
When sending data to a destination other than
an e-mail address, press [Yes].
[Specify Size].
[Email]