Tcp/Ip Panel - Extron electronics FOX3 Matrix Series User Manual

To edit the IP address:
1. Click on the Edit button (see figure 16,
on page 42). The Communication
3
Settings box opens.
2. Click in the field to edit (see figure 17).
3. Click Apply to complete and close.
Alternatively, click Apply and Connect
to complete and connect to the device.
Click Cancel to close the box without
changes.

TCP/IP Panel

The TCP/IP panel connects PCS to a specific device through Ethernet.
Figure 18.
1. Click the TCP/IP tab (see figure 18,
2. If connecting through the front panel USB-C port or the rear panel AV LAN port,
enter the IP Address/Hostname and Password in the Target Device panel (
Continue to
NOTES:
•
•
•
•
TCP/IP Panel
step 3 on page 44.
If the FOX3 Matrix is connected to the front panel USB-C, the hardcoded IP
address is 203.0.113.22. If connected to the rear panel AV LAN port, the
FOX3 Matrix default IP address is 192.168.254.254. If connected to the rear
panel IPCP control card LAN port, the default IP address is 192.168.253.250.
If the FOX3 Matrix IP address is changed, the AV LAN IP address
(192.168.254.250) MUST be changed in Toolbelt to the same subnet as the
FOX3 Matrix in order to connect through the LAN port.
The factory configured passwords for all accounts on this device have been
set to the device serial number. In the event of a complete system reset, the
passwords convert to the default, which is extron for the Admin and User
(see Roles and Permissions Panel
Select the Show Characters checkbox to display the password characters.
FOX3 Matrix Series Switcher • Product Configuration Software
Figure 17. Communication Settings Box
).
1
on page 64 to change a password).
).
2
43