Extron electronics FOX3 Matrix Series User Manual page 28

NOTE: The reset modes close all open IP connections and close all sockets. Also, the
Mode Activation
1 Hold down the recessed Reset button while
applying power to the switcher.
NOTE: After a mode 1 reset is performed,
update the switcher firmware to
the latest version. Do not operate
the switcher firmware version that
results from the mode 1 reset. If you
want to use the factory default firmware,
you must upload that version again (see
the Firmware Panel
details on uploading firmware).
4 Hold down the Reset button for about 6 seconds,
until the Reset LED blinks twice (once at 3 seconds
and again at 6 seconds). Then press and release
Reset within 1 second.
5 Hold down the Reset button for about 9 seconds,
until the Reset LED blinks three times (once at
3 seconds, again at 6 seconds, and then again at
9 seconds). Then press and release Reset within
1 second.
NOTE: The factory configured passwords for all accounts on this device have been set to the device serial
number. In the event of a complete system reset, the passwords convert to the default, which is extron for
the Admin and User (see
following modes are separate functions, not a continuation from Mode 1 to Mode 5.
Reset Modes
The switcher reverts to the factory default
firmware. Event scripting will not start if the
switcher is powered on in this mode. All user files
and settings (such as drivers, adjustments, and
IP settings) are maintained.
NOTE: If you do not want to update
on page 63 for
Mode 4:
•
•
•
•
•
•
•
The Reset LED flashes four times in quick
succession during the reset.
Mode 5 performs a complete reset to
factory defaults (with the exception of the
firmware):
•
•
•
•
•
The Reset LED flashes four times in quick
succession during the reset.
Roles and Permissions Panel
Result
firmware, or a mode 1 reset was
performed by mistake, cycle power to
the switcher to return to the firmware
version that was running before the
mode 1 reset (see Firmware Panel
to confirm that the factory default
firmware is no longer running (look for
the asterisk [*] following the version
number).
Enables ARP capability.
Sets the IP address to the factory default.
Sets the subnet address to the factory
default.
Sets the gateway address to the factory
default.
Sets port mapping to the factory default.
Turns DHCP off.
Turn events off.
Does everything mode 4 does.
Resets most all real time adjustments,
including:
clears all ties and presets
clears all mutes
clears all I/O grouping
clears all passwords
Resets all IP options.
Resets the fiber data rate setting to the
factory default (10G).
Removes and clears all files for the switcher.
on page 64 to change a password).
FOX3 Matrix Series Switchers • Operation
Purpose and Notes
Use mode 1 to revert
to the factory default
firmware version if
incompatibility issues
arise with user-loaded
firmware.
Mode 4 is useful to set
IP address information
using ARP and the
MAC address.
Mode 5 is useful
to start over with
configuration and
uploading or to replace
events.
20