Using The Zero Calibration Box; Notes On Use Of Zero Calibration Box - Konica Minolta CF-300 Instruction Manual

Using the Zero Calibration Box

WARNING
Do not perform measurement with the specimen measuring port directed
towards your face. Doing so may cause damage to your eyes .
Be careful around openings in the CF-300. Failure to do so may
result in fingers being trapped causing injury.
c Attach the target mask that is to be used in measurements to the instrument before performing calibration.
Procedure
1
. Fit the projections on the zero calibration box
into the recesses in the instrument, and press
the zero calibration box flush against the
instrument with your hand.

Notes on Use of Zero Calibration Box

c Take care not to scratch, touch, or make the inside of the zero calibration box dirty with such as fingerprints.
c If the inside of the zero calibration box gets dirty, wipe it with a soft, clean, dry cloth.
c If dirt is difficult to remove, dampen a cloth with commercially available lens cleaning liquid and wipe the
zero calibration box. Then wipe off the liquid with a cloth dampened with water, and leave the box to dry.
c Should the inside of the zero calibration box get so dirty that it
cannot be cleaned, replace the box with a new one.
18