Setting A Specimen (When Using The Benchtop Base); Reflectance Measurement - Konica Minolta CF-300 Instruction Manual

Setting a Specimen
WARNING
Do not use the CF-300 in places where flammable or combustible gases (gasoline fumes, etc.) are present.
Doing so may cause a fire.
Do not disassemble or modify the CF-300. Doing so may cause a fire or electric shock.
The CF-300 should not be operated if it is damaged, or smoke or strange odors occur. Doing so may result
in a fire.
In such situations, turn the power OFF immediately, disconnect the AC adapter from the
AC outlet, and contact the nearest Konica Minolta-authorized service facility.
CAUTION
Do not perform measurement with the specimen measuring port directed
towards your face. Doing so may cause damage to your eyes.
Be careful not to pinch hands in parts of the instrument or accessories
that open and close.Doing so may result in injury.

Reflectance measurement

c Before starting reflectance measurements, attach the target mask to be used for measurements
Procedure
1
. Pull the sample holder to the front and hold it
in the extended posture.
2
. <For contact measurements>
Clasp a specimen in the sample holder.
<For noncontact measurements>
Pull the sample holder to the front and hold it
in the extended posture.
Face the part of the specimen that is to be
measured towards the instrument and
immobilize it 1 mm from the specimen
measuring port so that it covers the specimen
measuring port.
3
. Remove the finder cap and look into the
finder to verify that the measurement point is
properly positioned for measurement.
Memo If using the optional SpectraMagic DX, the pointer
LED can be used to verify that the measurement
point is properly positioned for measurement.
(When using the benchtop base)
<For contact measurements>
<For noncontact measurements>
1 mm
24