Furuno FSS-3BB Operator's Manual page 104

5. MAINTENANCE AND TROUBLESHOOTING
Error
Error name
Icon
Processor Unit
System Error
Transceiver Unit
System Error
5-6
Error
Reason, remedy
code
P01 The voltage of the battery inside the Pro-
cessor Unit is low. Turn the equipment
off, then contact your local dealer to re-
quest replacement of the battery.
P02 The fan is in the Processor Unit is rotat-
ing too slowly. Turn the equipment off,
then contact your local dealer to request
replacement of the fan.
P03 Multiple alike IP addresses found. Turn
the equipment off, then contact your lo-
cal dealer for advice. (IP address setup
cannot be changed from this equipment.
Change the IP address at the external
device.)
T01 Communication error between the
Transceiver Unit and Processor Unit.
Turn the equipment off, then contact
your local dealer for service.
T02 The rotating speed of the fan in the
Transceiver Unit is abnormal. Turn the
equipment off, then contact your local
dealer for service.
T03 Overcurrent detected in the Transceiver
Unit. Turn the equipment off, then con-
tact your local dealer for service.
T04 TX voltage error detected in the Trans-
ceiver Unit. Turn the equipment off, then
contact your local dealer for service.
T06 Transducer connection error (short cir-
cuit) detected. Turn the equipment off,
then contact your local dealer for ser-
vice.
Priority
Order
3
4
5
2
6
7
8
9