Siemens SIDOOR AT40 System Manual page 94
Automatic door control units
Hide thumbs
Also See for SIDOOR AT40:
- System manual (337 pages) ,
- Operating instructions manual (6 pages) ,
- Operating instructions (4 pages)
Table of Contents
Advertisement
Controllers
5.7 Operating and parameterizing controllers
Parameters can be changed in the following three menus:
• "MAIN MENU > Quick setup > Parameter setting"
• "MAIN MENU > General setup > Profile parameters"
• "MAIN MENU > General setup > Special parameters"
The desired parameter is selected with the menu selection keys
setting with the Enter key
The parameter value can then be increased or decreased by pressing the corresponding key (see
above). The value is applied by pressing the Enter key again.
Menu navigation
You can find the menu navigation of the terminal module, SIDOOR SOFTWARE KIT, SIDOOR
SUPPORT app or SIDOOR SERVICE TOOL in the section SIDOOR SERVICE TOOL (Page 141).
Digital display "H1"
You can see the operating states on the "H1" display. You can find the meaning of the digital
display in the section Operating state display (Page 165).
Description
In addition to the parameter assignment options integrated in the controller, you can also assign
parameters via additional units. The following additional units are available for parameter
assignment:
• SIDOOR SOFTWARE KIT
The SIDOOR USER SOFTWARE is part of the SIDOOR SOFTWARE KIT. You can find a detailed
description of the SIDOOR SOFTWARE KIT in the SIDOOR SOFTWARE KIT Operating
Instructions (http://support.automation.siemens.com/WW/view/en/92711247).
• SIDOOR SERVICE TOOL
You can find a detailed description of the SIDOOR SERVICE TOOL in the section SIDOOR
SERVICE TOOL (Page 141).
• Virtual CAN terminal in accordance with CiA-417
A detailed description of the virtual CAN terminal functionality in accordance with CiA-417
is available in the section Virtual CAN Terminal (Page 78)
• SIDOOR LINK with SIDOOR SUPPORT app
You can find a detailed description in the section SIDOOR SUPPORT app and SIDOOR LINK
(Page 32).
92
Menu selection key – increases a parameter value
Menu selection key – decreases a parameter value
(parameter value flashes).
and , and activated for the
AT40 and ATD400V for elevators
System Manual, 06/2022, A5E42192709-AH
Advertisement
Table of Contents
