Siemens SIDOOR AT40 System Manual page 92

Controllers
5.7 Operating and parameterizing controllers
Setting of the function of input 1
Selecting the function of input 1:
1. Press the learn run button (S401) to set input 1.
2. The 7-segment display alternates between displaying an "||" and the current setting in the
form of a number from 0 to 2. (0: Light barrier, 1: DCPS, 2: deactivated)
3. Set the required function (0: Light barrier, 1: DCPS, 2: deactivated) by pressing the service
button S402 (downwards) or S403 (upwards).
4. Confirm by pressing and holding down the learn run button (S401) until the dot lights up on
the 7-segment display (> 2 seconds).
The dot on the 7-segment display indicates that the settings have been successfully stored.
Deactivating (exiting) the minimal editor
1. Disconnect the control device from the power supply by pulling the power plug.
2. Connect the control device to the power supply by plugging in the power plug.
Note
The line voltage can alternatively be connected and disconnected with the X3 connector directly
on the control device.
Performing a learn run
Note
The current driving parameters are overwritten by the factory parameters at the end of the learn
run if the learn run button (S401) is pressed at the same time as the line voltage is applied. If the
learn run button is pressed during operation, only the door width and weight are determined.
The driving parameters, force limits and continuous torques remain unchanged. The maximum
closing speed and the nudging speed are limited as a function of the determined weight.
The values preset by the minimum editor (travel profile, closing force) are overwritten by a
subsequent learn run with default parameters. A "normal" learn run does not overwrite the
preset values.
1. Push the door into the CLOSED position.
2. Perform a learn run during operation. Proceed as described in Table 4-3 Starting a learn run
during operation (Page 42).
90
AT40 and ATD400V for elevators
System Manual, 06/2022, A5E42192709-AH