Siemens SIDOOR AT40 System Manual page 121
Automatic door control units
Hide thumbs
Also See for SIDOOR AT40:
- System manual (337 pages) ,
- Operating instructions manual (6 pages) ,
- Operating instructions (4 pages)
Table of Contents
Advertisement
Procedure
Note
Risk of injury due to moving mechanical parts.
The controller is ready for operation after the supply line has been connected. If a control signal
is present, the door will move in the set direction.
Always connect the supply lines last of all!
Carry out the following steps in the given order:
1. Connect the control device to the output line, observing the polarity printed on the device.
2. Connect the supply lines to the network.
3. When the supply is switched on, the device is ready for operation.
The green LED lights up.
See section Connecting and commissioning. (Page 157)
AT40 and ATD400V for elevators
System Manual, 06/2022, A5E42192709-AH
Power supply
7.1 SIDOOR NT40
119
Advertisement
Table of Contents
