Siemens SIDOOR AT40 System Manual page 160

Connecting and commissioning
9.1 Overview of safety and commissioning
Parameter assignment and configuration
Risk of injury and material damage due to excessive force of the door
Exceeding the maximum static closing force or the opening force in some cases may lead to
injuries to persons or damage to the door drive and mechanical components of the door.
After commissioning, have the maximum static forces checked by the service personnel, and
adjusted to the limit value if it is excessive.
Note the limits of the applicable standard and adjust the setting accordingly.
Note
Application-specific measures for emergency operation
In the event of a control device failure, measures must be taken for emergency operation
according to the application.
Risk of injury due to excessive closing force of the door
The door must be closed completely within the slow end distance in the closing direction. The
driving curve parameter "Cutter distance CLOSE" must be checked and set accordingly.
Modifications to the door drive
Loss of liability for defects and material damage
Changes to the door drive lead to the loss of liability for defects and compensation rights, and
the correct function of the door drive is no longer guaranteed.
Observe the following rules:
• Do not make any modifications to the door drive (motor, controller, power supply).
• Do not make a permanent connection as this does not ensure a proper and required
• Do not remove the protective Schuko plug under any circumstances (for example by cutting
• The connection of the SIDOOR Transformer UL may only take place via a two-pole
• The power supply cord of the power supply (SIDOOR TRANSFORMER, SIDOOR
158
WARNING
WARNING
CAUTION
necessary disconnection from the mains.
it off).
disconnecting safety device.
TRANSFORMER UL or SIDOOR NT 40) cannot be replaced. Scrap the power supply if the
supply cable is damaged.
AT40 and ATD400V for elevators
System Manual, 06/2022, A5E42192709-AH