Set Skip Over Perforation; Cancel Skip Over Perforation - Intermec 6822P User Manual

6820 Series 80-Column Printer User's Manual
Minimum space between margins is the width of one double-width pica
character. Maximum value must be less than the right margin. Ranges
shown below could vary, pending on other parameter values that affect
character width. If the specified value is not within the range, it is
ignored.
Range of n is 0-78 in pica mode; 0-93 in elite mode, and 0-133 in
compressed mode.
Format
Decimal
27 108 n

Set Skip Over Perforation

Defines the number of lines to skip between the last printed line on the
page and the first printed line on the next page is set. If the value
specified for this function is greater than the page length, it is ignored.
This function is canceled by using one of the Set Page Length functions
(factory default = disabled). This function is valid for continuous paper
only.
The amount of space left blank at the bottom of the printed page is
dependent upon the current Line Spacing.
Format
Decimal
27 78 n

Cancel Skip Over Perforation

Cancels the skip over perforation, which allows the maximum number of
lines to print on each page.
Format
Decimal
27 79
Chapter 4 — Control Code Definitions
Hex
1B 6C n
Hex
1B 4E n
Hex
1B 4F
ASCII
ESC "l" n
ASCII
ESC "N" n
ASCII
ESC "O"
47