Intermec 6822P User Manual page 101

6820 Series 80-Column Printer User's Manual
the printer. In portable printers, raise the printer mechanism to look
for the number on the inside back wall.
•
Battery Voltage, (line 13)
Indicates the input voltage sampled at the beginning of the self-test.
The input range must be between 7.5 and 15 V. The input voltage
must be greater than 10.5 V to charge the internal battery. At 7.5 V or
less, the Low Batt LED comes on and the printer enters Sleep mode.
At 10.5 V or less, the Low Batt comes on but the printer still prints.
•
Auto Feed (line 16)
Auto feed is a configurable item. Carriage Return (CR) means no
auto linefeed. This is the most common setting for applications using
NPCP CR+LF means a line feed will be added to each CR. This
setting can produce double-spacing of reports. Set auto feed using the
Printer Configuration utility see
Utility" on page
•
Interface Mode (line 17)
Interface mode lists the interface protocol for the printer. The typical
setting is NPCP. Others include DTR with no, odd, or even parity,
and IrDA. Set Interface mode using the Printer Configuration utility
see "Using the Printer Configuration Utility" on page
• Bit Rate (line 18)
Bit rate is commonly set to 19200 (19.2K) or 9600 bps. See
"Selecting the Bit Rate" on page
•
A2D History (lines 21 through 25)
Shows the recorded history for voltage measurements and
temperature measurements.
•
Head Jam History (lines 26 through 29)
Provides information on head jams. If the printer is having frequent
head jams, these lines can assist in determining the problem.
Head Jam Information
Heading Description
Home Err indicates the home position LED sensor has failed.
Command Indicates which printer command was executed when the
head jammed.
Chapter 5 — Troubleshooting and Maintaining the 6820
"Using the Printer Configuration
21.
29.
21.
87