Perform N/216-Inch Reverse Line Feed; Perform Master Reset; Set Print Position (Absolute) - Intermec 6822P User Manual

Perform Master Reset

Set Print Position (absolute)

6820 Series 80-Column Printer User's Manual

Perform n/216-inch Reverse Line Feed

Reverses the line feed by n/216 of an inch. This does not affect
subsequent line feeds. Range of n is 0-255.
Format
Decimal
27 106 n
Initializes the printer and restores factory installed printer defaults, (see
"Factory-Installed Printer Defaults" on page 143
of settings that are initialized with this command).
Format
Decimal
27 64
Moves the printhead to an absolute horizontal position on the paper. The
distance is specified in dots from the left margin to the new print position
(at which subsequent characters are printed). Each dot represents 1/60 of
an inch. The values for n1 and n2 determine the distance, as follows:
number of dots = n1 + (n2 * 256)
Maximum position is 480. The previous contents of the current print
buffer is printed.
If the position specified moves the printhead outside the current margins,
the command is ignored and the previous setting remains in effect. This
command is also ignored in right, center, and full justification modes.
Format
Decimal
27 36 n1 n2
Chapter 4 — Control Code Definitions
Hex
1B 6A n
Hex
1B 40
Hex
1B 24 n1 n2
ASCII
ESC "j" n
for a complete list
ASCII
ESC "@"
ASCII
ESC "$" n1 n2
41