Setting The 6820 Configuration - Intermec 6822P User Manual

6820 Series 80-Column Printer User's Manual
To view the settings on your 6820
1 Click the Get 6820 Configuration button to initiate communication.
2 The "Getting printer parameters . . . " message appears when the
Printer Configuration Utility retrieves configuration information
from the printer.
3 The message "Getting printer parameters . . . Done" appears after
configuration information is retrieved.
4 Modify configuration settings or click OK to close the Printer
Configuration Utility.

Setting the 6820 Configuration

Use the Printer Configuration Utility to set or modify the 6820
configuration setting, install or remove fonts, or load an updated printer
control program.
To modify configuration settings
1 Make changes to the Configuration Clipboard or click the Reset to
Defaults button to undo your selections and return them to their
defaults.
Note: When using a Bluetooth adapter you must select the DTR
communications protocol and a bit rate of 19.2 K.
2 Click the Set 6820 Configuration button to initiate communication
with the printer. The "Setting printer parameters . . ." message
appears when you initiate communication with the printer.
3 The "Setting printer parameters . . . Done" message appears when
configuration parameters are set.
Note: The "Unable to set printer parameters" message indicates a
dropped connection between your PC and your printer.
4 If the configuration is complete, click OK to close the utility and
detach the serial cable.
Chapter 3 — Configuring the 6820 Printer
29