Intermec 6822P User Manual page 103

----------------------------------------------------------------------------------
------------------------------------------------------- 1NP6820
2 Copyright 1997, 1998, Intermec Technologies Corporation.
3Serial# MFG Date
412345678 yy/mm/dd
5
6
7
8Revisions:..........0000000000303100
9Bootblock:
10Control Program:
11Font Module:
12Font Module:
13Battery Voltage:
14Total Pages:
15Zero Font Style:
16Auto Feed:
17Interface mode:
18Bit Rate:
19Cold Starts:
20Warm Starts:
21A2D History
22 Curr
2324v: 024.00 023.21
2412v: 012.55 010.91
25Temp: 023
6820 Series 80-Column Printer User's Manual
Error Log Information (continued)
Heading Description
Temp Unused
OverC Number of head over-current errors (typically caused by a
bad printhead)
HeadS Number of head driver short errors (typically caused by
circuit failures)
Fault Number of paper feed motor over current errors (excess
current in paper feed motor could indicate circuit failure)
ADErr Number of A2D conversion failures
EEErr Number of EEPROM write failures to diagnostic block
Dlink Number of software memory errors (corruption in internal
memory)
Llink Number of software memory errors
Sample First Page of the Self-Test
Note: Lines 15-18 are factory default printer settings. Take note of these
lines when reading the self-test report.
Hardware
ddd-ddd-ddd/dddd (TOP)
ddd-ddd-ddd/dddd (MLB)
ddd-ddd-ddd/dddd (PS)
ddd-ddd-ddd/dddd (IOB)
NPBB6820.MOD
npfl6820.mod
nftxxxxx.mod
nftxxxxx.mod
012.34 Low...../....High
123456
O
CR
NPCP
19200
00024
00050
Low High
023.91 023.21
013.51 010.90
-020 055
Chapter 5 — Troubleshooting and Maintaining the 6820
Check
GO/NG
- Version XX.XX
- Version XX.XX
- Version XX.XX
- Version XX.XX
Min Max
024.51 027.21
014.50
-021 060
All Rights Reserved.
Repairs Svc Date
00 yy/mm/dd
XXXX XXXX GO/NG
XXXX XXXX GO/NG
XXXX XXXX GO/NG
XXXX XXXX GO/NG
Error Page Count
00401 00021
8.71 00401 00021
000 00401 00021
89