Adjusting The Pinfeed Holders - Intermec 6822P User Manual

Adjusting the Pinfeed Holders

6822 Series 80-Column Printer User's Manual
5 Raise the paper bail.
1
Positioning the Paper
Note: There are two pinfeed holders, one next to the green thumb wheel
and one opposite the same wheel. Always loosen the pinfeed holder
opposite the green thumb wheel.
Note: Adjusting the pinfeed holder next to the green thumb wheel may
cause information to print in the wrong place. If this pinfeed holder is
moved, correct its location by releasing the pinfeed holder tab, moving
the pinfeed holder as close to the green thumb wheel as possible, then
locking the pinfeed holder tab, before adjusting the opposite pinfeed
holder.
To adjust the pinfeed holders
1 With the pinfeed holders open, release the locking tab on the pinfeed
holder opposite the green thumb wheel.
2 Adjust the pinfeed holder position so that the pins align with the
paper.
3 Close the pinfeed holder.
Chapter 2 — Installing the 6820 Printer
3
2
5
4
15