700 Series Or Ck60 To 6820 Pass Through; Series, Ck60, Or Cn3 To Bluetooth Module Communication Interface; Radio Power On/Off Mechanism - Intermec 6822P User Manual

700 Series or CK60 to 6820 Pass Through

700 Series, CK60, or CN3 to Bluetooth Module
Communication Interface

Radio Power On/Off Mechanism

6820 Series 80-Column Printer User's Manual
Appendix B — Bluetooth Configuration Commands and Specifications
state, the 700 Series or CK60 must not have an open terminal holder
COM port and the specially designed programming adapter must be
engaged.
The interfaces on the Bluetooth adapter that allow for the different
modes are detailed below:
Note: Pass through printing requires shutting down the
Bluetooth portion of the adapter. To reenable Bluetooth
functionality after you finish pass through printing, press a
button on the control panel to wake the printer.
When DTR on the 700 Series or CK60 is set, the adapter board
automatically opens a path between the 700 Series of CK60 and the 6820
Transition/DC Board and powers down the Bluetooth module. Testing
the DSR pin to reflect DTR allows the mobile computer to differentiate
between a Bluetooth-equipped terminal holder and a non-Bluetooth
equipped terminal holder.
The Bluetooth adapter allows a 700 Series, CK60, or CN3 to
communicate directly with the Bluetooth module under two
circumstances.
•
When the configuration settings of the Bluetooth module are to print.
•
When the Bluetooth module requires reconfiguration.
The Bluetooth adapter, including the Bluetooth radio shuts down after a
configurable time (default is two hours of idle time). To wake the
Bluetooth adapter, the 6820 is powered on by any button push on the
printer control panel. There are two ways to shutdown the Bluetooth
module power:
•
a 700 Series, CK60, or CN3 mobile computer initiates a pass through
mode
129