Changing Configuration Settings - Intermec PW50 User Manual

Chapter 2 — Configuring the PW50

Changing Configuration Settings

16
5 Close the media cover. You are now in Extended Test mode.
• Press and hold the Feed button for at least 2 seconds to cycle
through the Extended Test mode option.
• Press and release the Feed button select an Extended Test
mode option.
Options in Extended Test Mode
Option Description
Select Media This option is similar to the process in Test mode, except
that the printer performs a slow test feed in Extended Test
mode. The slow test feed enables the printer to perform a
slow sensor calibration, which can help resolve gap or
mark detection problems.
Test Labels This option allows you to print test labels one at a time.
Press the
Dump Mode This option enters Dump mode. For more information
on Dump mode, see
Communication Problems" on page
Factory Default This option restores the factory default settings. Press the
Feed
Setup and Exit This option exits Extended Test mode and puts the
printer in Setup mode.
Exit This option exits Extended Test mode.
There are several ways you can change the configuration settings of
the printer. You can change the configuration settings:
• from the host PC using PrintSet.
• from the host PC using the command line.
• from the SmartSystems Console.
Feed
button to print the next label.
"Troubleshooting
button to select this option.
PW50 Workboard Printer User's Guide
27.