Setting Up Wireless Communication - Intermec EasyCoder PF2i Installation Instructions Manual

Chapter 4 — Setup in Fingerprint

Setting Up Wireless Communication

General
Once a wired serial communication is established, see Chapter 3, page
24, you can use Fingerprint setup strings or setup fi les to set up the
necessary EasyLAN Wireless parameters. All settings are saved in fi les on
the printer fl ash memory. If a factory default upgrade is performed, all
settings described in this section are set to their (factory) default values.
Th e default allowed user is . All settings are restricted to read-only
admin
for all users except the allowed user, who can change all settings. If unau-
thorized access is attempted, error 1076 (Operation not permitted) will
occur. Settings beginning with a period "." character are read-protected
from non-authorized users. Some settings are not possible to read even
by the allowed user, for instance WEP keys, which return the same string
regardless of the actual key.
Display Current User
To display who the current user is in Fingerprint, the "whoami" com-
mand is used.
Syntax:
RUN"whoami"
Note: Th is command is case-sensitive.
Th e command echoes the current user to the standard out channel.
Example:
RUN"whoami"
user
Ok
28 EasyLAN Wireless Interface Kit Installation Instructions