I Scan Resume Condition - Icom IC-R5 Instruction Manual

6
SCAN OPERATION

I Scan resume condition

D D Scan pause timer
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2–20 sec. or unlimited.
q Push [TS•SET] for 1 sec. to enter set mode.
w Rotate [DIAL] to select "EXPAND" item.
eWhile pushing [FUNC], rotate [DIAL] to turn the expand set
mode selection ON.
r Rotate [DIAL] to select "PAUSE" item.
tWhile pushing [FUNC], rotate [DIAL] to set the desired
scan pausing time from 2–20 sec. (2 sec. steps) and
"HOLD."
• "2SEC"–"20SEC": Scan pauses 2–20 sec. while receiving a sig-
• "HOLD" : Scan pauses on a received a signal until it
y Push [TS•SET] to exit set mode.
31
nal.
disappears.
• Pause timer setting
[DIAL]
[FUNC]
After 1 sec.
[TS•SET]
Setting indication
D D Scan resume timer
The scan re-starts after a signal disappears according to the
resume time. it can be set from 0–5 sec. or unlimited.
q Push [TS•SET] for 1 sec. to enter set mode.
w Rotate [DIAL] to select "EXPAND" item.
eWhile pushing [FUNC], rotate [DIAL] to turn the expand set
mode selection ON.
r Rotate [DIAL] to select "RESUME" item.
tWhile pushing [FUNC], rotate [DIAL] to set the desired
scan pausing time from 0–5 sec. (1 sec. steps) and
"HOLD."
• "0SEC" : Scan restarts immediately after the signal dis-
appears.
• "1SEC"–"5SEC" : Scan restarts 1–5 sec. after the signal disap-
pears.
• "HOLD" : Scan restarts by rotating [DIAL] only.
y Push [TS•SET] to exit set mode.
[DIAL]
[FUNC]
[TS•SET]
EXPANDED SET MODE
USING
• Resume timer setting
After 1 sec.
Setting indication