Scan Resume Condition - Icom IC-PCR1500 Instruction Manual

I Scan resume condition
When receiving a signal, scan automatically pauses on that
signal. The scan resume condition sets the time that the scan
pauses before resuming or whether scan stops instead of
pausing.
D Using the multi-function receiver screen or
component screen
qClick the [SET] button to call up the [Scan Delay] screen if
it is not displayed.
wSelect the scan delay condition from "Pause until Signal
Disappears", "Delay Volume" or "Scan Stop."
(a) 'Pause until Signal disappears'
Scan pauses when receiving a signal and remains paused
until the signal disappears.
(b) 'Delay Volume'
When setting a delay time using the [DELAY] control (on
multi-function receiver screen or component screen), scan
pauses when receiving a signal and then resumes after the
specified delay.
(c) 'Scan Stop'
When a signal is received during scan, scan stops and
does not resume.
eSelect a restart delay time from [Restart Delay]. This set-
ting is valid when selecting (a) or (b) in step w.
• 0 Sec. : Scan resumes immediately after the signal dis-
appears.
• 1 Sec. : Scan resumes 1 sec. after the signal disappears.
• 2 Sec. : Scan resumes 2 sec. after the signal disappears.
rClick the close ([X]) button to close the setting screen.
SCAN OPERATION
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
50