I Memory Clearing - Icom IC-R5 Instruction Manual

I Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
qPush [V/M•S.MW•~] for 1 sec. to select select memory
write condition.
• 1 short and 1 long beeps sound.
• " " indicator and memory channel number blink.
• Do not hold [V/M•S.MW•~] for more than 2 sec. otherwise the
memory contents will be copied to VFO.
wRotate [DIAL] to select the desired memory channel to be
cleared.
eWhile pushing [MODE•SCAN], rotate [DIAL] to select
"CLEAR."
• After releasing [MODE•SCAN], "CLR" is displayed instead of the
frequency indication, and only "
• "CLEAR" item can also be selected by pushing [MODE•SCAN]
several times.
[DIAL]
[V/M•S.MW•~]
[MODE•SCAN]
" indicator blinks.
After [MODE•SCAN]
released
MEMORY CHANNELS
r Push [V/M•S.MW•~] for 1 sec. to clear the contents.
• 3 beeps sound.
• Return to VFO or memory mode, if VFO is selected before per-
forming the step q.
• Return to select memory write conditions if memory mode is se-
lected before performing the step q.— "
and channel number blink. Push [V/M•S.MW•~] momentarily
to return to memory mode.
Push
While pushing [FUNC], push [V/M•S.MW•~] for 1 sec.
after the step w is operated can also be cleared the mem-
ory contents. In this case, the steps e and r are not nec-
essary.
NOTE: Be careful!— the contents of cleared memories
CANNOT be re-called even in bank channel opera-
tion.
5
" indicator memory
for 1 sec.
5
22