I Scan Edges Programming - Icom IC-R5 Instruction Manual

6
SCAN OPERATION

I Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 00A/00B to 24A/24B, in memory channels.
q Push [V/M•S.MW•~] to select VFO mode.
w Set the desired frequency:
➥ Select the desired band with [BAND•
➥ Set the desired frequency with [DIAL].
➥ Set other data
, if desired.
squelch, etc.)
ePush [V/M•S.MW•~] for 1 sec. to select select memory
write condition.
• 1 short and 1 long beeps sound.
• " " indicator and memory channel number blink.
rRotate [DIAL] to select the desired programmed scan edge
channel from 00A to 24A.
[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.
Push
FM
27
].
(e.g. offset frequency, duplex direction, tone
for 1 sec. Rotate
P SKIP FM
t Push [V/M•S.MW•~] for 1 sec.
• 3 beeps sound
• The other scan edge channel "B," 00B to 24B, automatically se-
lected when continuing to push [V/M•S.MW•~] after program-
ming.
yTo program a frequency for the other pair of scan edges,
00B or 24B, repeat steps w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
Push for 1 sec.
FM
[DIAL]
[V/M•S.MW•~]
P SKIP FM P SKIP