Scan Resume Condition - Icom IC-R2500 Instruction Manual

6
SCAN OPERATION

■ Scan resume condition

The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch. (p. 47)
q Push [MAIN•AGC] (or [MAIN•NB])to select the desired
band (left or right) as the main band.
w Push [SET•SKIP] to enter set mode.
[SET•SKIP]
[MAIN•AGC]
[MAIN•NB]
e Push [SET•SKIP] or [ATT•PRIO] several times until "SCt"
or "SCP" appears.
[SET•SKIP]
[ATT•PRIO]
33
The display shows that the
scan will resume 15 sec. after
it stops.
r Rotate the main band's [DIAL] to set the desired timer:
• "SCP-2" : Scan pauses until the signal disappears and then
resumes 2 sec. later.
• "SCt-15" : Scan pauses 15 sec. while receiving a signal.
• "SCt-10" : Scan pauses 10 sec. while receiving a signal.
• "SCt-5" : Scan pauses 5 sec. while receiving a signal.
[DIAL]
t Push any switch for the main band to exit set mode.
SET MODE
USING