Other Functions; I Antenna Selection - Icom IC-R5 Instruction Manual

I Antenna selection

The IC-R5 has an internal bar antenna for receiving AM
broadcast band
(0.495–1.620 MHz)
connected earphone's cable can be used as an antenna for
receiving FM broadcast band
signals.
cording to version)
D D Selecting antenna
q Select VFO mode with [V/M•S.MW•~].
wPush [BAND•
] several times, or while pushing
[BAND• ] rotate [DIAL] to select the AM or FM broad-
cast band.
e Push [TS•SET] for 1 sec. to enter set mode.
r Rotate [DIAL] to select "ANT" item.
• "ANT" disappears after 1 sec. and "EXT" (default) and "An" ap-
pear.
[DIAL]
[FUNC]
[TS•SET]
EXPANDED SET MODE
USING
signals. In addition, the
(76.000–107.995 MHz; differ ac-
After 1 sec.

OTHER FUNCTIONS

tWhile pushing [FUNC], rotate [DIAL] to select "BAR" when
set mode has accessed from the AM broadcast band; se-
lect "EAR" when set mode has accessed from the FM
broadcast band.
Bar antenna selection
for 0.495–1.620 MHz band
y Push [TS•SET] momentarily to exit set mode.
NOTE:
• Some noise or spurious may be received when the inter-
nal bar or earphone cable is used for antenna.
• The supplied or third party's antenna MUST BE con-
nected to the antenna connector to receive signals other
than AM or FM broadcast bands.
• When receiving an AM broadcast signal with internal bar
antenna, aim the receiver to better audio direction.
• When the internal bar or earphone cable is used for an-
tenna, the attenuator function cannot be used.
10
Earphone cable selection
for 76.000–107.995 MHz band
9
10
48