I Full/Band/Programmed Scan - Icom IC-R5 Instruction Manual

I Full/band/programmed scan

q Select VFO mode with [V/M•S.MW•~].
• Select the desired frequency band with [BAND•
w Set the squelch to the point where noise is just muted.
ePush [MODE•SCAN] for 1 sec. to enter scanning type se-
lection condition.
r Rotate [DIAL] to select the desired scanning type.
• "ALL" for full scan; "BAND" for band scan, "PROGxx" for pro-
grammed scan (xx= 0 to 24; programmed scan edges numbers
only displayed)
[DIAL]
[MODE•SCAN]
], if desired.
• Full scan selection
• Band scan selection
• Programmed scan selection
Selectable between " 0" to "24"
if programmed
t To start the scan, push [MODE•SCAN].
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
• Push [MODE•SCAN] again to stop the scan.
• During full/band scan
FM P SKIP
NOTE: Instead of the steps e to t operations, while
pushing and holding [MODE•SCAN], rotate [DIAL] to se-
lect the desired scan type. In this case, scan starts when
releasing [MODE•SCAN].
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
SCAN OPERATION
• During programmed scan
FM P SKIP
6
6
26