Memory Clearing - Icom IC-R6 Instruction Manual

5
MEMORY CHANNELS

Memory clearing

Contents of programmed memories can be cleared (erased),
if desired.
q Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The " " icon and memory channel number blink.
• Do not hold down [S.MW](V/M) for more than 2 seconds.
Otherwise the memory contents will be copied to the VFO.
w Rotate [DIAL] to select a desired memory channel to be
cleared.
e While holding down [MODE], rotate [DIAL] to select the
"CLEAR" item.
• The "CLEAR" item can also be selected by pushing [MODE]
repeatedly.
• After releasing [MODE], "CLR" is displayed and the "
blinks.
25
[DIAL]
After
released.
r Hold down [S.MW](V/M) for 1 second to clear the con-
tents.
• 3 beeps sound.
• The cleared channel changes to a blank channel.
• Return to the select memory write mode.— The "
memory channel number blink.
Push and hold
t Push [V/M] to return to the screen displayed before you
the select memory write mode in step q.
After step w, while holding down [FUNC], push and hold
[S.MW] (V/M) for 1 second can also be clear the con-
tents. In that case, steps e and r are not necessary.
BE CAREFUL!— The contents of cleared memories
CANNOT be recalled, even in the bank channel mode.
" icon
" icon and
for 1 sec.