Table of Contents
Advertisement
4
MEMORY OPERATION
I Memory clearing
Contents of programmed memories can be cleared (blanked),
if desired.
qPush [V/MHz•SCAN] to select VFO mode.
wPush [S.MW•MW] to select the select memory write con-
dition.
• "!" and the memory channel number blink.
eRotate [DIAL] to select the memory channel to be cleared.
• Memory channels not yet programmed are blank.
17
rPush [S.MW•MW] momentarily, then push [S.MW•MW]
again for 1 sec.
This operation must be performed within 1.5 sec.
• 3 beeps sound.
• The cleared channel changes to blank channel
• "!" and the memory channel number blink continuously.
tPush [V/MHz•SCAN] to return to VFO mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
Advertisement
Table of Contents
