Memory Clearing - Icom IC-R2500 Instruction Manual

5
MEMORY OPERATION

■ Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
q Push [VFO/MR•S.MW] to select VFO mode in the main
band.
w Push the same band's [VFO/MR•S.MW] for 1 sec. to enter
select memory write mode.
• "!" indicator and the memory channel number blink.
e Rotate the same band's [DIAL] to select the memory
channel to be cleared.
• Memory channels not yet programmed are blank.
[EXAMPLE]: Clearing memory channel 20.
VFO/MR
Push to select VFO.
S.MW
SET
Push three times, then push
SKIP
25
VFO/MR
Push for 1 sec.
S.MW
VFO/MR
for 1 sec.
S.MW
"
Beep
"
Beep
"
r Push [SET•SKIP] three times to select "CLEAR," then
push and hold [VFO/MR•S.MW] for 1 sec.
• 3 beeps sound.
• The cleared channel changes to blank channel
• "!" and the memory channel number blink continuously.
t Push the same band's [MAIN] or [MHz•TS] to exit select
memory write mode, or repeat steps e and r to clear
other channel.
y Push the same band's [VFO/MR•S.MW] to return to VFO
mode.
☞NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
Rotate for selecting memory channel.
Push any switch for main band
other than VFO/MR , then push
S.MW
"
Beep
"
VFO/MR to return to VFO.
S.MW