I Memory Clearing - Icom ID-1 Instruction Manual

D D Copying with the RC-24
qSelect the desired memory or call channel with [DIAL] or
keypad to be copied.
• Push [V/M] or [CALL] to select memory mode or call channel, if
desired.
w Push [MW•6] momentarily.
• The previously selected memory channel number blinks.
[MW•6]
eRotate [DIAL] to select VFO, the desired memory or call
channel to be programmed.
• Select " " when copying to VFO.
• Select " " to " " when copying to memory channel.
• Select " " to " " when copying to call channel.
• The display shows the currently programmed frequency and set-
tings.
• Push [V/M] to select a blank memory channel, push [CALL] to
select call channel 1.
r Push [MW•6] for 0.5 sec. to program.
• 3 beeps sound.

I Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
D D Clearing from the application
q Click [MW] to display the Memory programming screen.
w Click to select the "MEMORY."
eSelect the desired memory channel number to be cleared
LOW
rClick [M-CL] on the Memory programming screen to clear
tTo close the Memory programming screen, click [MW] on
MEMORY/CALL OPERATION
— main screen
by right clicking or left clicking on the [DIAL] in the screen.
Click to
select.
Shows the selected memory
channel number and previ-
ously programmed frequency.
the contents.
the main screen again or click " . "
10
Right click to move memo-
ry channel number up.
Left click to move memory
channel number down.
10
78