Icom ID-1 Instruction Manual page 74

9
DATA OPERATION
D D Setting from the RC-24
q Push [MODE] to select DD (Data) mode.
• " " appears.
w Set the near-by repeater frequency.
e Push [RP•4] several times to select "
• " " displayed briefly.
[RP•4]
[MODE]
rPush [CS•
•1] to enter call sign select mode, then rotate
[DIAL] to select the gateway repeater call sign.
• Refer to the pages 42 to 44 for call sign setting when the desired
call sign is not programmed.
tPush [CS•
•1] one more time to select "
tate [DIAL] to select the desired near-by repeater call sign.
• Refer to the pages 42 to 44 for call sign setting when the desired
call sign is not programmed.
yPush [CS•
•1] one more time to select "
tate [DIAL] to select the gateway repeater call sign.
67
uPush [
when the repeater requires the "G" setting.
• " " appears beside the call sign.
."
LOW
NOTE: When the near-by repeater is gateway repeater,
push [
ting into "
iPush [CS•
mode.
o Push [TXinh•
," then ro-
• "
• Starts accessing to the gateway repeater.
!0 S tart up a web browser then access to the desired web
," then ro- site.
!1 P ush [TXinh•
mission) from the gateway repeater.
] for 0.5 sec. to enable the gateway connection,
[DIAL]
[ ]
[CS• •1]
] for 0.5 sec. (if necessary) after the call sign set-
" in step t and skip step y.
•1] once (or twice) to exit call sign select
] to release transmission inhibit.
" appears instead of " " indication.
] again to disconnect (inhibit the trans-
LOW