Table of Contents
Advertisement
B-2 Card configurations
Standard 1.0
July 1997
Notes:
1
The ACL-30 is always a clock master on the PEB.
2
Set the appropriate jumpers to ground the shield for each BNC connector
in use.
BNC Connector
Port 1 TX1
Port 1 RX1
3
Each PEB connection requires one D/320-SC card.
4
Terminate the PEB at both ends to ensure proper electrical
characteristics. The ACL-30 has built-in PEB terminators, so you must
install the ACL-30 at one end of the PEB cable. You must remove all
PEB terminators from the resource cards (TTS, VR, Fax) on the PEB.
5
The ACL-30 uses shared memory range E0000 to EFFFF.
6
Only one ACL-30 card per system is allowed.
Grounding Jumper
JP32 - ON
JP31 - ON
Advertisement
Table of Contents
