Table of Contents
Advertisement
4-12 Installing the Aculab E1/PRI signaling option
Standard 1.0
July 1997
9
When your International signaling parameters are correct, enter y.
Press <Enter>.
The system displays the following:
Installing files...
Updating the tunable kernel parameters
The kernel has been retuned
The UNIX Operating System will now be
rebuilt.
This will take a few minutes. Please wait.
Root for this system build is /.
The UNIX Kernel has been rebuilt.
Backing up /unix to /unix.old
Installing new /unix
Setting up new kernel environment
The system must now be rebooted for the new
parameters to take affect
The Nortel xxx Country Parameters
have now been installed.
/sci/install>
10
Make sure that the last installation diskette has been removed from the
disk drive.
11
At the /sci/install> prompt, enter restart and press <Enter>.
The system verifies the integrity of the newly installed packages, and
informs you of any inconsistencies.
12
The MRS starts shutting down. The system automatically reboots once
it reaches the shutdown state.
13
Allow the system to boot up normally. It takes several minutes.
14
If this is a new installation or a restoration of the signaling option, then
you must activate the signaling option as described in "Activating the
signaling option" on page 4-17. If this is part of an upgrade from
Release 2.01/S to 2.5/S, then it is not necessary to activate the feature.
Advertisement
Table of Contents
