Table of Contents
Advertisement
7
Type y and press <Enter>.
The system displays the following:
Configure DPNSS with bits A/X or B/Y [ab]:
Note: When responding to this prompt, use the opposite type of
master/slave communication that the switch uses. For example, if the
switch is configured for A/X communication, select B/Y. If the switch is
configured for B/Y communication, select A/X.
8
Type a and press <Enter>.
The system responds with the following:
Do you want to edit the space.0 file [y/n]:
9
Type y and press <Enter>.
The system prompts you to verify the current configuration:
This system will be configured using xxx Enhanced
parameters
ACL Type = xx port
ACL Firmware = xxxxx
DPNSS Signalling = X/X
10
When your International signaling parameters are correct, enter y and
press <Enter>.
The system displays the following:
Installing files...
11
After a few moments, the system displays the following prompt:
Do you wish to continue the installation [y/n]:
12
Type y and press <Enter> to continue.
The system displays the following prompt:
Do you wish to manually edit the Aculab Space.c
file? [y/n]
Nortel IVR 2.5/S
Installing the Aculab E1/PRI signaling option 4-15
Aculab-Based E1 CAS/ISDN PRI Signaling Guide
Advertisement
Table of Contents
