Installing The Front Wheel - Husqvarna FS 450 2019 Repair Manual

14.7.2

Installing the front wheel

Warning
Danger of accidents
Always keep the brake discs free of oil and grease.
Clean the brake discs with brake cleaner when necessary.
Oil or grease on the brake discs reduces the braking effect.
Check the wheel bearing for damage and wear.
If the wheel bearing is damaged or worn:
-
Change front wheel bearing.
Clean and grease shaft seal rings
surfaces
I
Long-life grease
Insert the spacers.
H00935-10
Info
Insert the wide spacer on the brake disc side.
Insert the narrow spacer on the opposite side.
Clean and grease the wheel spindle.
I
Long-life grease
Position the front wheel and insert the wheel spindle.
Mount and tighten screw @.
Guideline
Screw, front wheel
spindle
Position the brake caliper. Mount screws
8
ers but do not tighten yet.
✓ The brake linings are correctly positioned.
Operate the hand brake lever repeatedly until the brake lin­
ings are in contact with the brake disc and there is a pressure
point. Fix the hand brake lever in the activated position.
✓ The brake caliper straightens.
Tighten screws
Guideline
Screw, front
brake caliper
Remove the locking piece of the hand brake lever.
(IUI
O
6)
of the spacers.
(IUI p. 306)
(IUI p. 306)
M24x1 .5
@).
M10x1 .25 45 Nm (33.2 lbf ft)
WHEELS 14
p. 122)
and contact
45 Nm (33.2 lbf ft)
@)
with wash­
Loctite ® 243
™
121