Table of Contents
Advertisement
Procedures
Set the input coupling of the waveform measurement
1
instrument to GND, adjust the zero position of the
display.
2
Set the input coupling of the waveform measurement
instrument to DC.
Connect the output
3
connector of the device to
the BNC input connector of
the waveform measurement
instrument.
Insert the connector
until it clicks into place
so that it is securely
locked in position.
The device can be connected when the locking pin
on the waveform measurement instrument's BNC
input connector is in either the horizontal or vertical
orientation.
Preparation for Measurements
39
Advertisement
Table of Contents
