Table of Contents
Advertisement
Usage Notes
Reference
An increase in the volume of the resonant sound during
use may indicate that the gap between the upper and
lower sensors has increased in size. Since the sensor
the device (see "4 Maintenance and Service" (p. 5 7)).
Precautions after measurement
• To prevent wire breaks, do not pull on the cord
• Observe the following precautions when
22
to disconnect the output connector from the
waveform measurement instrument. Always grip
the terminator and pull the unlock lever toward
you before disconnecting the connector.
disconnecting the device in order to prevent wiring
breaks in the device's power cord or damage to
the PS-54 or PS-52 Power Supply receptacle:
• Grip the power supply plug's shell (p. 2 5)
when disconnecting it.
• Do not pull on cords to disconnect them or
twist the power supply plug. (Pulling on the
power supply plug's shell causes the lock to be
released so that it can be disconnected from
the power supply receptacle.)
CAUTION
Advertisement
Table of Contents
