Table of Contents
Advertisement
Usage Notes
Precautions during measurement
• Do not measure around a bare conductor.
• Refer to the derating characteristics when
• Observe the following to avoid electric shock and
• Connect the device to the PS-54 or the PS-52
• When the sensor is opened, do not short- circuit
10
Doing so may result in short-circuit or electric
shock. Take measurements at a location on an
insulated wire where there is sufficient
insulation for the circuit voltage.
measuring current that includes a high- frequency
component and never measure any current that
exceeds the rated current. Use with high
frequencies or strong magnetic fields may cause
the device to become abnormally hot, resulting in
fire, equipment damage, or burns. (See "3
Specifications" (p. 4 5).)
short circuits.
Power Supply and waveform measurement
instrument (oscilloscope or recorder) first, and
then to the active lines to be measured.
the conductor being measured or other two wires
with the metal part of the tip.
DANGER
Advertisement
Table of Contents
