Fitting Instructions - 3M PELTOR WS LiteCom Pro III MT73H7 4D10EU Series Manual

D:17 On/Off/Mode button (silicone)
D:18 + button (silicone)
D:19 – button (silicone)
D:20 PTT button for built-in two-way radio (PBT)
D:21 Bluetooth button (PBT)
®

FITTING INSTRUCTIONS

Headband
E:1 E:2
E:1 Slide out the cups and tilt the top of the cup out, as the
cable must be on the outside of the headband.
E:2 Adjust the height of the cups by sliding them up or down
while holding the headband in place.
E:3 The headband should be positioned across the top of
your head.
Neckband
E:4
E:4 Place the cups in position over the ears.
E:5 Keep the cups in position, place the head strap on top
of your head and lock it tight in position.
E:6 The head strap should be positioned across the top
of your head.
Helmet Attachment
E:7 E:8
E:10 E:11
E:7 Insert the helmet attachment in the slot on the helmet
and snap it into place (E:8).
E:9 Work mode. To switch the unit from ventilation mode
to work mode, press the headband wires inwards until you
hear a click on both sides. Make sure that the cups and the
headband wires do not press on the edge of the helmet when
work mode as this can cause noise leakage.
E:10 Ventilation mode. Avoid placing the cups against the
helmet (E:11) as this prevents ventilation.
FP3806_rev_a.indd 4
4. OPERATING INSTRUCTIONS
4.1 Programming the Headset
Your headset comes pre-programmed with a specific
configuration. Please contact your certified two-way radio
dealer or 3M Technical Service for any questions regarding
the headset configuration, including:
• Radio frequencies/channels
• Voice guide language
• Menu configuration
E:3
• Power management settings
• Two-way radio transmission settings
4.2 Charging/Replacing the batteries
WARNING: For intrinsically safe models, only use the
3M
E:6
E:5
Cable AL2AH, and 3M
(or equivalent SELV 5V power supply).
For non intrinsically safe, use only 3M
charged with cable 3M
3M
WARNING: The battery may not be charged if the ambient
temperature exceeds 45
The battery can be charged in a powered off Headset, or
separately.
E:9
Insert the rechargeable battery in the battery compartment.
Push down the latch.
The headset will automatically power off 2 hours (default
value) after the last button press or VOX activation.
4.3 Power On/Off
Press and hold the On/Off/Mode button for two seconds until
a voice message is heard to power the headset on or off.
4.4 Adjusting the volume level
Use the [+] and [–] buttons to adjust the volume. By default,
the [+] and [–] buttons will control the volume of the active
sound source, which could be any one of the following:
Two-way radio, Bluetooth
sound. When receiving a two-way radio signal, the [+] and [–]
buttons will control the two-way radio volume. If connected
4
PELTOR Battery ACK082, 3M PELTOR™ Charging
™ ™ ™
PELTOR Power Supply FR08
™ ™
TM
PELTOR AL2AI connected to a
TM TM
PELTOR FR08.
TM TM
C or 113 F.
° °
communication, or Surround
®
GB
PELTOR ACK081
TM
2017-01-25 09:39:59