Fitting Instructions - 3M Peltor LiteCom Plus MT7H7A4610-NA Manual

EN
COMPONENTS
(A:13)
(A:1)
A. Headband Model MT7H7A4610-NA
A:1 Headband
(A:2)
A:2 Headband padding
A:3 Headband wire
A:4 Headband guide
A:5 Ear cushion
A:6 Foam liners
A:7 Cup
A:8 Environmental microphone
A:9 Speech microphone
(A:3)
A:10 On/Off/Mode button
A:11 (+) button
A:12 (–) button
A:13 Antenna
(A:4)
A:14 Speech microphone input (J22)
A:15 PTT (Push-To-Talk) button for built-in two-way radio
A:16 PTT (Push-To-Talk) button for auxiliary two-way radio
A:17 Auxiliary port
A:18 Lithium-ion battery
(A:7)
B. Hard Hat Attached Model MT7H7P3E4610-NA
(A:11)
B:1 Cup supporting arm
(A:10)
C. NeckBand Model MT7H7B4610-NA
(A:12)
C:1 Neckband wire
(A:9)
C:2 Neckband cover
(A:8)
Note: Adjustable over-the-head strap not shown
(A:5)
(A:6)
(A:18)
(A:17)
(B:1)
(C:2)
(C:1)
(A:15)
(A:16) (A:14)

FITTING INSTRUCTIONS

Headband
D:1 Slide out the cups and tilt the top of the shell out, as the cable must be on the outside of the headband.
D:2 Adjust the height of the cups by sliding them up or down while holding the headband in place.
D:3 The headband should be positioned across the top of your head
as shown and should support the
weight of the headset.
D:1 D:2 D:3
6