Cleaning And Maintenance; Spare Parts And Accessories - 3M PELTOR WS LiteCom Pro III MT73H7 4D10EU Series Manual

4.7.2 Operating your Bluetooth
NOTE: The latest paired Bluetooth
operate via the Headset.
Bluetooth Action
®
Scenario (BT button on
the left cup)
If Bluetooth Long press
®
device is
connected but
no activity
If Bluetooth
Short press
®
device is
connected and
Long press
receiving an
incoming call
If Bluetooth Short press
®
device is con-
nected, and has
an ongoing call
SMART TIP: You can also stream music from your Bluetooth
device.
If Bluetooth Short press
®
device is
Double short
connected, and
press
streaming is
ongoing Triple short press
Long press
4.8 Communicate via connected external radio
Connect your external communication radio via the auxiliary
port (cable not included). To transmit, use the PTT button on
the radio or external PTT adapter.
4.9 Communicate face to face (push-to-listen)
The surround microphones can be activated from off or low
state with a double press on On/Off/Mode button.
Press any other button to deactivate push-to-listen.

5. CLEANING AND MAINTENANCE

Use a cloth wetted with soap and warm water to clean the
cups, headband and cushions.
NOTE: Do NOT immerse the hearing protector in water.
If the hearing protector gets wet from rain or sweat, turn the
earmuffs outwards, remove the cushions and foam liners,
and allow to dry before reassembly. See Spare Parts Section
below. Keep the earmuffs clean and dry and store recom-
mended storage temperature in a clean uncontaminated area
before and after use.
FP3806_rev_a.indd 6
device via the Headset • Operating temperature range: -20°C to 55°C
®
• Storage temperature range: -20°C to 55°C
device is the one you
®
5.1 Removing and replacing cushions
F:1
Feature
Voice dial
F:1 To remove the cushion, slide your fingers under the edge
of the cushion and firmly pull straight out.
F:2 To replace, insert the foam liners.
F:3 Then, fit one side of the cushion into the groove of the
Answer call
cup and then press on the opposite side until cushion snaps
in place.
Reject call
5.2 Replacing the helmet attachment plate
Hang up
G:1
®
For proper fitting on different industrial safety helmets, the
helmet attachment plate may need to be replaced. Find the
recommended attachment in Table B. The headset comes
assembled with P3E helmet attachment, while other plates
Play/Pause
can be obtained from your dealer. A screwdriver is needed to
Next track
replace the helmet attachment plate.
G:1 Loosen the screw holding the plate and remove the plate.
Previous track
G:2 Attach the appropriate plate while ensuring the left (L) and
Voice dial
right (R) designated plates are on the appropriate earmuff, if
applicable, and then tighten the screw.

6. SPARE PARTS AND ACCESSORIES

3M
Hygiene kit consisting of two foam pads, two foam rings and
snap-in ear cushions.
3M
Single-use protector for the ear cushions. Package of
100 pairs.
3M
Moisture and wind-tight tape. Protects the speech micro-
phone. Package of 5 meters for about 50 replacements.
3M
microphones
Wind noise protector for MT73-type speech microphones.
Two per package.
6
F:2
G:2
PELTOR HY83 Hygiene kit
TM TM
PELTOR HY100A Clean – single-use protectors
TM TM
PELTOR HYM1000 Mic Protector
TM TM
PELTOR M171/2 Wind shield for MT73 speech
TM TM
GB
F:3
2017-01-25 09:40:01