Installing the front VGA board
Figure 188: Installing the front VGA board
▶ Push the front VGA connector in the corresponding recess (1) and fasten
the front VGA board with two screws (2).
▶ Route the cable tie under the front VGA board (3).
Concluding steps
▶
"Installing the front panel module" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
13.4.2
Removing the front VGA board
Upgrade and Repair Unit
(URU)
Tools:
Phillips PH1 / (+) No. 1 screw driver
RX1330 M4
52.
56.
58.
Upgrade and Maintenance Manual
271.
Hardware: 10 minutes
Front panel
275