Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 162

Hard disk drive (HDD) / solid state drive (SSD)
Figure 80: Connecting the cables to the ODD and the 4x 2.5-inch HDD backplane
1 ODD power cable (if applicable)
2 ODD data cable (if applicable)
3 SAS cable to connector "X5"
▶ If applicable, push the ODD in its bay until the ODD latch engages.
▶ Connect all cables to the ODD and the HDD backplane.
For the cable plans, see
Concluding steps
▶ Insert all HDD/SSD modules, see
on page 152.
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
162
4
5
"Appendix B" on page
"Installing 2.5-inch HDD/SSD modules"
52.
56.
58.
Upgrade and Maintenance Manual
OOB cable to connector "SMBus"
Power cable
365.
RX1330 M4